Keypad Installation
1. Undo the screw on the bottom of the keypad and remove back cover.
2. Insert the battery.
3. Secure the back cover with 2 screws at the selected location.
4. Slide the keypad unit to the back cover and secure with the
bottom screw.
To operate the garage door opener with the keypad:
Enter the [PIN] + [#]. The factory default PIN is 0 0 0 0.
You can enter [0 0 0 0 #] to operate the garage door opener.
To change the PIN, follow the instructions below:
1. Enter the current
PIN + [*]
, i.e.
[0 0 0 0 *]
if you are changing from
factory default PIN.
2. Enter a new PIN (2 to 8 digits) + [*], such as
[1 2 3 4 *]
.
3. Re-enter the new PIN again,
[1 2 3 4 *]
.
4. If the new PIN is accepted, keypad will emit 3 beeps.
5. Try with the new PIN to operate the garage door opener by
entering
[New PIN] + [#]
.
It is not necessary to reprogram the keypad to the garage door
opener after changing the PIN.
If the keypad does not operate the garage door opener, please follow
instructions Page 23 Programming additional remote / keypad to
program the keypad to the garage door opener.
Keypad
28
