SkyLink ATOMS ANR Series, Инструкция по эксплуатации

Страница: 10 / 32

INSTALL THE DOOR BRACKET
INSTALL THE DOOR BRACKET
INSTALL THE DOOR BRACKET
One-Piece Wood Doors
For wood doors, drill 5/16” (8 mm) holes through the door and
secure bracket with 5/16 x 2” (8 x 50 mm) carriage bolts, lock
washers and nuts (not included).
One-Piece Metal Doors
Drill two 3/16” (5 mm) pilot holes. Use 2 self-threading screws
to secure the door bracket.
CAUTION
Lightweight garage doors are not designed for use with garage door opener must be
equipped with a door reinforcement kit. Check with the garage door manufacturer for more
information. Many door reinforcement kits provide for direct attachment of the clevis pin and
door arm. In this case, you will not need the door bracket, proceed to “Install the Door Arms”
section.
Sectional Wood Doors
For wood doors, drill 5/16” (8 mm) holes through the
door and secure bracket with 5/16 x 2” (8 x 50 mm)
carriage bolts, lock washers and nuts (not included).
Sectional Metal Doors
Align the door bracket on the centreline 2 ” to 4” (5 to 10
cm) below the top edge of the door, or directly below any
door structural support.
Drill two 3/16” (5 mm) pilot holes. Use 2 self-threading
screws to secure the door bracket.
Top of Door
Door Bracket Location
Door arm connects directly
to vertical reinforcement
Hardware
(not included)
Bolt 5/16 x 2” (8 x 50 mm) (not included)
Bolt 5/16 x 2” (8 x 50 mm) (not included)
Centre the door bracket on the top of the door.
19 19 20 20
E3 (x2)
E3 (x2)