SkyLink ATOMS ANR Series, Инструкция по эксплуатации

Страница: 14 / 32

Important Information: The safety beam sensor can detect obstacles in the path of its invisible beam.
When the beam is obstructed while the door is closing, the door will stop immediately, reverse to the
fully open position and the opener lights will flash. It is important to ensure the invisible infrared is
unobstructed by any part of the garage door, tracks, other hardware or objects near the garage door.
Avoid sunlight shining directly into the safety beam sensors.
3. Mounting the Sensor on the Door Track
4. Mounting the Sensor on the Wall (Optional)
For wall mounting, use a wooden block to increase depth providing enough clearance for the sensor
beam to be unobstructed.
5. Mounting the Sensor on the Floor (Optional)
For floor mounting, use a wooden block to elevate the sensor brackets, if necessary. Ensure the
sensor is no higher than 6” (15 cm) above floor. Fasten the screws to the floor with concrete
anchors (not included).
WARNING
• The safety beam sensor must be installed and aligned properly.
• This safety device must not be disabled.
• The safety infrared sensor must not be installed higher than 6” (15 cm) above the garage floor.
INSTALL SAFETY BEAM SENSOR
INSTALL SAFETY BEAM SENSOR
INSTALL SAFETY BEAM SENSOR
27 27 28 28
1
2
4” to 6”
(10 to 15cm)
3
4
Wood Block
Lag Screws
Lag Screws
MASTER UNIT
1. Identify the Master and the Slave unit
The unit with the marking “Master unit” and the ‘SET’ button is the Master unit.
•
2. Setup the Wireless Safety Beam Sensor
Undo the screw on the bottom side of the Safety Beam Sensor (Master
and Slave unit).
Pry out the front cover from the back cover.
Insert 3 AA batteries in position. Beware of the polarity.
Attach the front cover to the back cover and tighten the
screw on the bottom of the unit.
NOTE
Six 1.5V Alkaline Type (AA size) batteries (sold separately)
required for the Wireless Safety Beam Sensor.
•
Screw
AA batteries
Slide (1) and clip (2) the mounting bracket
onto the garage door track.
Ensure the sensor is mounted
between 4” (10 cm) and 6” (15 cm)
above the ground.
Follow the same procedure to
install the sensor on the other track
ensuing the sensors are facing
each other.