Skyjack SJ6832 RTE Series, Руководство по эксплуатации

Страница: 59 / 112

59
SJ6832 RTE
221844ACAI
Use the Hybrid Power Pack (HPP) (optional equipment) Section 5 – Operation
5.12 Use the Hybrid Power
Pack (HPP) (optional
equipment)
DANGER
DO NOT operate the HPP in enclosed areas
without adequate ventilation for exhaust gas and
fumes. Failure to follow this warning could cause
death or serious injury.
WARNING
Environmental hazard. Immediately remove diesel
fuel hydraulic fluid spills and leaks with rags.
Discard these rags in accordance with national,
state/provincial/territorial, and local regulations.
Spilled fluids can damage the environment. When
spilled fluids go into the water (for example, a
sewage system, streams, rivers, or other surface
water), they can kill aquatic life.
CAUTION
Make sure the HPP is off before you connect the
MEWP to an AC power supply. If you do not
obey, there is a risk of machine damage.
1.
Turn the
main power disconnect
switch to the
on position.
2.
Pull the
emergency-stop
button on the base
control console.
3.
Pull the
emergency-stop
button on the platform
control console.
4.
Move the
HPP mode
switch to the automatic
position
(AUTO)
or to the manual position
(M)
.
Refer to
section 3.6-2
for information about the
modes.
5.
Move the
HPP on/off
switch on the base control
console to the on position.
6.
Move the
HPP on/off
switch on the platform
control console to the on position.
▪
Result:
In manual mode, the HPP starts. In
automatic mode, the HPP automatically starts
when the battery falls below 50% charge.
7.
To stop the HPP in manual mode, move the
HPP
on/off
switch to the off position. In automatic
mode, the HPP stops automatically when the
battery reaches 90% charge.
IMPORTANT
In order to stop the HPP, both emergency stop
buttons must be pulled out.
NOTE
For additional starting options and maintenance
information, refer to the HPP manufacturer’s manual.
5.13 MEWP shutdown
WARNING
Look for overhead obstructions or other possible
hazards around the MEWP when you raise the
platform. Do not lower the platform unless the area
below is clear of personnel and obstructions. If
you do not obey, there is a risk of death or serious
injury.
1.
Select a reasonably well-protected location to
park the MEWP. This location must have a firm,
level surface, clear of obstructions, and traffic.
2.
Fully lower the platform.
3.
Push the
emergency-stop
button.
WARNING
Fall Hazard. Use the three points of contact
principle when you use the MEWP ladder to enter
or exit the platform. If you do not obey, there is a
risk of death or serious injury.
4.
Use the MEWP ladder to exit the platform.
5.
Turn the
platform/off/base key
switch to the
off position on the base control console and
remove the key.
6.
Push the
emergency-stop
button.
7.
Turn the
main power disconnect
switch to the
off position.