SKY-HERO ANAKIN ARF, Руководство пользователя

Страница: 5 / 19

5
44
PREPARE YOUR ANAKIN
3
To your RX (Receiver) PPM & S.BUS
To your RX (Receiver) - DSM
For PPM & S.BUS please use black, red, yellow and blue cable.
YELLOW: Not used
BLACK: Ground
RED: +5V
BLUE: Signal
This instruction is for se ng up the inbuilt CC3D flight controller that comes with your ANAKIN FPV ARF .
If you use Sky-Hero Link 9 radio with its receiver go to page XX
Mount your receiver on the upper frame with double-sided tape.
Sky-Hero CC3D flight controller is only compatible with:
S-BUS receivers
JR & Spektrum Satellite receivers
PPM receivers
Please note that PWM (Pulse With Modulation) is NOT SUPPORTED!
Pay attention to bind your R (receiver) to your T (your radio) before connecting it to the Sky Hero CC3D Flight controler
Sky Hero CC3D
You will need to know exactly what kind of receiver you are using as different receivers request totally different setup steps. ANAKIN FP s inbuilt
Sky-Hero CC3D supports 3 kinds of receivers: PPM, S.BUS and DSM.
PP P LSE POSI ION OD LA ION
A PPM signal (often referred to as a PPM stream) is basically a series of P M signals (described above) sent one after another on the same wire. So
instead of continuously sending the information for 1 channel or servo, the information for all servo s or ESCs is sent in a row on the same wire. The
advantage of such a PPM signal is that only one signal wire is needed instead of all the individual wires.
For PPM receiver, the HITE and REY wire of the multi colored signal wire needs to be swapped FIRST, then connect the REY RED BLACK plug to
the PPM output of your receiver, no other wires need to be connected. See below:
S.BUS
The S.Bus is another communication protocol from Futaba that can also be used on other radios like Taranis and Radiolink. It also combines all output
channel information into single servo lead.
For S.Bus receiver , use the S.Bus signal wire and connect it to the S.Bus port on the main board, remove the multi colored P M PPM signal cable from
its socket.
DS SPEK R R SA ELLI E ONNE ION
Another receiver option is the Spektrum R Satellite. It allows a Spektrum R or OrangeR satellite receiver to be connected to the CC3D.
For J R/Spektrum/DSM satellite receiver, plug the signal wire on the satellite to the DSM port on the main board. Then swap the ORANGE and BLACK
wire at any end of the plug. (see explanation on next page)
USING LINK9 RADIO & RECEIVER
Please referr to the related chapter on page 14
STEP 1: CONNECT YOUR RX
signal cable from the
Wire 1 (black): Gnd/Negative
Wire 2 (red): Positive
Wire 3 (yellow): Not used
Wire 4 (blue): S.Bus Signal
NOTE: Only wire 1, 2 and 4 are used for the
S.Bus connection. In our example that means
Black, Red and Blue - but colours may be
different for some cable.
one of the 4 wire cables.
«Input» socket.