Sky Drone
c/o Skylab Mobilesystems Ltd.
1104 Crawford House, 70 Queen’s Road Central, Central
Hong Kong
EN English
4.
Setup the hardware
Unpack the hardware set and assemble the unit:
•
Screw in the two antennas.
•
Connect the power supply either via the supplied uBEC module that is connected to
a LiPo battery or via any other 5V power supply that delivers >2A*.
◦
Alternatively, the system comes with a spare cable that you can cut and connect
to your power supply. It uses a JST-GH connector following the Dronecode
standard. See “Analog Power” on
https://wiki.dronecode.org/workgroup/connectors/start
•
Connect the USB WiFi module via the USB-C cable to the unit. The camera does
not need to be connected for the setup procedure.
•
Optional: connect your flight controller via the telemetry port. The system uses a
JST-GH connector following the Dronecode standard. See “Telemetry Port” on
https://wiki.dronecode.org/workgroup/connectors/start
•
Insert a data-enabled nano SIM card. PIN protected SIM cards are currently not
supported. Please disable any PIN by temporary using it in a mobile phone to
disable.
* Note: It is essential to use a power supply with at least 2A of output. If in doubt, use a
fully charged LiPo battery.
© Sky Drone
Sky Drone FPV 3 – Manual
Page 6/42
