Page 2 of 4
2- Peel the paper protectors off back side of the "SENSOR BOARD" . Align as shown in
Fig. 2. The Sensor Board MUST completely cover the line selector buttons on the phone
and fit flush against the phone. Once you are SURE it is aligned correctly, press down
firmly to adhere to phone.
Fig #2
Before
After
3- Position the CK-1P10 box under the base telephone with the jacks facing towards the
back of the phone. (See Fig. 3).
4- Connect the short modular cord from [1&2 to Phone] on the CK-1 to the [LINE 1/2]
jack on the Phone.
5- Connect a MOD cord from Telephone Wall Jack 1&2 to [1&2 to Line] on CK-1.
6- Connect one end of the audio cord to the CK-1P10 in the AUDIO IN jack. Connect the
other end to the output of your audio player. Do NOT use the supplied Audio Adapter on
the CK-1P10 side.
7- Connect the POWER CUBE from the CK-1 box to 115VAC power.
