SKS-Kinkel Elektronik GmbH
Indoor station HTV4600, Receiver, 6-wire
EN
Support Hotline: +49 (0) 2661 98088-112
Support E-Mail: [email protected]
Version No. 3.0
Document No. 97003704
34
Connect the terminals to the previously installed cable. The termi
-
nals are located at the back of the HTV4600 indoor station.
The pre-assembled cables are then connected to the HTV4600
indoor station.
To avoid errors when connecting cables please use the plan-
ning guide or the wiring diagram.
E+ E- b a
V+ V- Gnd +22
Adresse
PT
V1
V2
Adresse
PT
V1
V2
Set the SKS BUS call address at the DIP switch on the back of the
HTV4600 indoor station. Each address is assigned to a bell button
at the door station. The SKS BUS table of call addresses can be
found in the appendix.
Pay particular attention to the setting of the DIP switch when
the HTV4600 indoor station is replaced!
In the following plug the terminals into the HTV4600 indoor station.
Remount the HTV4600 indoor station in the upper part of the sup
-
porting frame.
Subsequently press the indoor station onto the frame until it clicks
into place.
7.4
Disassembly
Open the HTV4600 indoor station as described in chapter “Preparation” and remove it from the support frame. Re
-
move the terminal plugs from the indoor station and if necessary the support frame by unscrewing it.