sks FS 4510, Руководство пользователя

Страница: 17 / 29

~ 17 ~
6. Operating Instructions
Function Button Procedure
Accept call
Push the talk button after the unit has been rung.
Two-way communication
Once a call is accepted, you can use the talk button to deactivate hands-free
speaking. As long as the talk button is pushed you can speak from the
intercom to the door station. By not pushing the button it is just possible to
communicate from the door station to the intercom. Two-way communication
is only active for the duration of the call.
Silent mode
Push the silent key (for about 5 seconds) until you hear the confirmation tone
(3 tones of equal length). Now the ringer is deactivated. To indicate this
status, a red LED will blink once every second.
The ringer will be turned on again automatically after 12 hours or
after a power outage.
Turn ringer on
Push the silent mode button once. You will hear a continuous, high-pitched
signal tone. The ringer is now activated again.
Open door
If the device is rung, the door can be opened within 2.5 minutes using the
open door button.
Change house call tune
+
Push the sound button and then quickly press the open door button within 2
seconds. A different tune will sound with each push of the button. When the
desired tune plays, release both buttons. 8 different buttons are available.
Change floor call tune
+
Push the sound button and then quickly press the open door button within 2
seconds. A different tune will sound with each push of the button. Wait until
the desired tune plays, then release both buttons.
There are 4 different floor call tunes.
Change ring volume
Push the sound button until the desired volume is reached. There are five
different sound settings to select from.
Light and special button
+
Only on the HT4500-
4. The special button “S” is used standard for switching
in combination with a switching actuator 4507. Furthermore, pushing the light
button closes an internal potential-free contact at the intercom unit. The light
button can be used optionally to switch the switching actuator. Please
indicate if you want to use this option when ordering.
Internal Call
+
The function “Internal Call” is only available on special models. If you need
this function, please inform us when placing your order.
Up to 2 call addresses are possible. The light button and the special button
can be configured for this function. A button configured for internal calling
cannot be configured for switching with the switching actuator.
Push the talk button and release it and then push and hold the button
configured for internal calling until the confirmation tone is emitted.