4
MACHINE INSTALLATION & PREPARATION
The key cutting machine can be installed by the purchaser and does not require any special skills.
However, some checks and preparation for use need to be carried out by the operator.
CHECKING FOR DAMAGE
The key cutting machine is solid and compact and will not normally damage if transport, unpacking
and installation have all been carried out according to the instructions in this manual. However, it is
always advisable to check that the machine has not suffered any damage.
INSTALLATION
•
Remove the machine from the box and place it in its working position on a flat bench or
counter
•
Ensure that there is adequate lighting in the area and there is adequate space surrounding
the machine
•
Fit the front handles to the key carriage and secure hand tight
•
Fit the eye shield
•
Fit the bulb cover and bulb
•
Remove the red protective caps on the followers (4 & 13) before use
•
Connect the machine to the mains power supply
•
Switch the main power switch (11) on
•
Check motor operation by switching the round switch (10) on
Please note, although the machine is calibrated at the factory, it is possible that the machine settings
are disturbed during transit. Please see ‘Machine Adjustment’ on page
s 6-7 for instructions on how
to check and calibrate the machine.
ENVIRONMENTAL CONDITIONS
•
Use in dry, well ventilated areas
•
Ideal operating temperature 10°C - 40°C
Содержание CYCLONE
Страница 1: ...1 CYCLONE CYCLONE PLUS MANUAL ...
