DA 3800 Flange Inlet
18
Mounting Guide
3.4.6 Oblique walls
If the inside wall is sloping, you may have to mount a
heavy-duty plate or wedges between the inlet and the
wall to avoid distortion of the inlet.
It is essential to adjust for the distortion when mounting
in sloping walls. Otherwise, the inlet flap does not close
tightly after the inlet is inserted.
The inlet frame is adjusted using wedges,from section
Mounting clamp for the pull rod [
.
Check that the inlet flap still closes tightly every time a
screw is tightened. Otherwise, you have to adjust the
wedges until the inlet flap closes tightly again.
Remove the redundant part of the wedge when all the
screws have been tightened.
