Skoda Octavia III 2013, Руководство по обслуживанию

Страница: 57 / 172

The engine is factory-filled with quality multigrade oil, which can
also be used as an all-season oil, except in extremely cold climatic
zones.
– Reinsert the screw cap.
– Start engine and check for leaks.
DANGER!
Instructions for engines with exhaust gas turbocharger:
After the first engine start, change the engine oil and the oil
filter and comply with the following:
♦ The engine must only run in idle when the oil pressure
warning light is lit in the dash panel insert.
♦ Do not accelerate!
♦ Once the oil pressure warning light goes out in the dash
panel insert, the full oil pressure is reached and acceler‐
ating is possible.
In case of sudden gas shocks, the turbocharger can be dam‐
aged or totally destroyed!
The turbocharger runs at very high speeds and can therefore
be severly damaged or totally destroyed within a few seconds
due to insufficient bearing lubrication!
Switch off the engine immediately in the event of an oil leakage,
vibrations or unusual noise from the turbocharger.
– Check the engine oil level again and top up with oil if necessary
⇒ “3.6 Inspecting engine oil level”, page 46 .
– Wait at least 3 minutes after topping up the oil again before
inspecting the oil level again
⇒ “3.6 Inspecting engine oil level”, page 46 .
– Install the noise insulation.
Note
The oil level must not be above the -max- marking to avoid dam‐
age to the catalytic converter
⇒ “3.6 Inspecting engine oil level”, page 46 .
3.8 Replace engine oil filter
⇒ “3.8.1 Replace oil filter with replacement oil filter for petrol en‐
gines ”, page 54
⇒ “3.8.2 Replace oil filter with replacement oil filter insert for petrol
engines ”, page 54
⇒ “3.8.3 Replace oil filter insert for diesel engines ”, page 55
Special tools and workshop equipment required
♦ Old oil collecting and suction equipment e.g. - VAS 6622-
♦ Oil filter tool - 3417-
Octavia III 2013 ➤ , Octavia III 2014 ➤
Maintenance - Edition 12.2014
53
ProCarManuals.com