Skoda Octavia III 2013, Руководство по обслуживанию

Страница: 159 / 172

After the ignition is switched on the warning light “PASSENGER
AIRBAG ON” -arrow- must not light up in the centre of the dash
panel.
At the same time, the warning light in the dash panel insert comes
on for about 4 s after the ignition is switched on and then must go
out.
WARNING
The key switch for the front passenger airbag must only be
operated when the ignition is switched off. Non compliance
may result in a fault at the airbag system (risk from the following
airbag deployment).
If the warning light in the dash panel insert lights up for approx.
4 s after the ignition is switched on and if the warning light then
flashes for a further 12 s, this indicates that the front passenger
airbag has been electronically blocked with the diagnostic unit.
If the warning light in the dash panel insert does not go out or
flashes while driving, a system fault is present ⇒ Vehicle diag‐
nostic tester.
7.11 Inspect original trailer coupling device
Inspecting condition of the support for the trailer coupling device
– Inspecting condition of the support shaft (contamination,
grease).
Clean the non treated and contaminated support shaft and treat
with -G 052 778 A2- .
– Check proper operation of the cap for the support shaft.
Replace the defective or damaged cap for the support shaft.
Inspect the condition of the trailer arm
– Inspect the rotation of the operating lever in open condition.
If the operating lever is difficult to turn or does not turn at all, the
jamming eccentric in the trailer arm housing must be cleaned and
treated with -G 052 778 A2- . If there is no improvement, the trailer
arm must be sent for repair to the manufacturer or replaced with
a new one.
– Inspect the rotation of the operating lever in closed condition.
If the operating lever can be turned more than 5°, the trailer cou‐
pling device is defective and must not be operated. Send the
trailer arm for repair to the manufacturer or replace it with a new
one.
– Check the turning of the key in the lock.
If the catch bolt in the operating lever is difficult to move or does
not move at all, it can be caused by the following:
♦ Lock defective: Replace bolts with lock
♦ Operating lever bent: Have manufacturer repair or replace
trailer arm
♦ the bolt is jammed: clean, treat with -G 052 778 A2- and put
into motion. If this does not help, send it for repair to the man‐
ufacturer or replace it with a new one.
Octavia III 2013 ➤ , Octavia III 2014 ➤
Maintenance - Edition 12.2014
7. Body
155
ProCarManuals.com