6
Press the PREV. button again to access the “
BEADS ON/OFF
” menu item. From this display
screen, press (
+
) to turn on the beads, and (
-
) to turn the beads off. The beads can be turned ON
or OFF while painting.
MONITOR MENU
To change to the COUNTERS Menu, from the MAIN Menu, press the menu keys (
PREV.
and
NEXT
) two times.
The
PREV.
button changes to the previous counter channel.
The
NEXT
button changes to the next counter channel.
The (
+
) button held for three seconds, erases the counter channel shown on the display.
The (
-
) button held for three seconds, erases
all
counter channels, including
ODOMETER, and PUMPs.
SKIP-TIMER OPERATION
CONTROLS
CYCLE and STRIPE LENGTH controls may be adjusted at any time, in motion or at rest.
TO ADJUST STRIPE LENGTH: (PAINT MENU)
(
+
) button to increase, or lengthen the stripe.
(
-
) button to decrease, or shorten the stripe.
The skip-timer displays and is calibrated for one-tenth-of-a-foot nominal resolution. In other
words, the dial can alter the paint pattern by approximate one-tenth-of-a-foot increments.
TO ADJUST CYCLE LENGTH: (PAINT MENU)
(
+
) button to increase or lengthen the repeat pattern.
(
-
) button to decrease or shorten the repeat pattern.
The cycle is measured from the BEGINNING of one stripe to the BEGINNING of the next stripe.
< Stripe >
< Stripe >
< Cycle Length >
The CYCLE adjustment is calibrated in one-tenth-of-a-foot increments.
NOTES:
The STRIPE length will probably need to be set shorter than the desired paint pattern,
because most paint guns respond more quickly to turn "on" than "off". They "hang-on" and
