SKI 18BDC, Руководство владельца/оператора

Страница: 33 / 53

28
KSi 18BDC CONVEYOR
USER'S MANUAL
Conveyor Belt Care
1. It is recommended that the conveyor belt be washed off and the tail end be cleaned out at the end of
the season. This will help prevent material residue from building up and causing damage to the belt.
2. In order for the water to drain from the conveyor belt, the splice must be parked on the top side of the
circuit. To obtain this condition, open the door at the tail end. Run the conveyor until the belt splice
appears. Turn off the conveyor immediately. The splice will now be on the top side.
Drive Belts
1. Inspect the V-belts on the drive system at the beginning and end of each season. If cracks or wear
are evident, replace the belts. Belt tension will need periodic adjustment.
Lubrication
1. Bearings (25 Hr Interval) – Lubricate bearings on belt drive/idler rollers
2. Use a good quality lithium soap base E.P. grease meeting the N.L.G.I. #2 specifications and
containing no more than 1% molybdenum disulfide to lubricate all fittings (Example: Shell Super Duty
or equivalent).
Tracking the Belt
1. Basic rule: the belt moves toward the end of the roller that it contacts first.
2. Rollers must be square with the housing and parallel to each other.
3. Belt tension must be great enough to prevent slippage. Tension to 20-23 ft-lbs. on adjustments
bolts.
CAUTION: Make sure everyone is clear
of machine before running.
4. Run the conveyor. Check to see that the belt runs centered on the idler roller. Turn off the
machine. Adjust idler roller if necessary.
WARNING: Do not run the machine while adjusting.
Failure to heed may result in personal injury or death.
5. To adjust idler roller, loosen the four nuts on the bearing holder plate, and the jam nut on the
threaded adjuster. Retighten after adjusting is complete.
CAUTION: Make sure everyone is clear
of machine before running.