SKI 18BDC, Руководство владельца/оператора

Страница: 30 / 53

25
KSi 18BDC CONVEYOR
USER'S MANUAL
6 – Operation
Operation Recommendations
1. One person must be in a position to monitor the operation of the conveyor at ALL times. That
person should visually inspect the conveyor before and during operation and be alert to any
unusual vibrations, noises, or loosening of fasteners.
2. For smoother startups, keep the conveyor from starting totally full. This will also ensure efficient
operation.
3. In cold weather, run empty conveyor for five minutes to warm up belt. Otherwise, do not operate the
conveyor empty for long periods of time.
4. You must “break-in” the conveyor when it is new and at the beginning of each season. Refer to
“Startup and Break-in” section for instructions.
5. Make sure the drive end is empty before shutting down the conveyor.
Emergency Shutdown
1. If you have to immediately shut down the conveyor under load, be sure to disconnect and lockout
the power source.
2. Remove as much grain as possible from the hopper and the conveyor before restarting.
3. Never attempt to restart the conveyor when it is full.
4. When as much grain as possible has been cleared from the hopper and the conveyor, reconnect the
power source and clear the remaining grain gradually.
Section
Do not stop or start the conveyor under load because the belt has a tendency to slip on
the drive pulley, especially if the belt and tube have not become well-polished.
IMPORTANT: Do not restart the conveyor when it is loaded. This may damage
the conveyor.