![Ski-Doo REV XP 2008 Series Скачать руководство пользователя страница 96](http://html1.mh-extra.com/html/ski-doo/rev-xp-2008-series/rev-xp-2008-series_operators-manual_1287420096.webp)
TROUBLESHOOTING
Beeper Codes
Beeper codes are used to inform you on the DESS system operation and/or as a
complement of the pilot lamps to catch your attention if an anomaly occurs or to
inform you of a particular condition.
For more details on DESS system beeper codes, refer to
DESS PILOT LAMP
CODES
in
TETHER CUT-OUT SWITCH
.
For more details on gauge pilot lamps, refer to
GAUGE PILOT LAMPS
.
For any beep code not listed in this Operator's Guide, refer to an authorized
SKI-DOO dealer.
General
ENGINE IS CRANKED BUT FAILS TO START.
1. Engine cut-out switch is in OFF position or tether cord cap (DESS key)
away from post.
–
Place engine cut-out switch in the ON position and install tether cord cap
(DESS key) on post.
2. Mixture not rich enough to start cold engine.
–
Check fuel tank level and check starting procedure, particularly use of the
choke.
3. Flooded engine (spark plug wet when removed).
–
Do not choke. Remove wet spark plug, place engine cut-out switch in OFF
position and crank engine several times. Install clean dry spark plug.
–
Start engine following usual starting procedure. If engine continues to
flood, see an authorized SKI-DOO dealer.
4. No fuel to the engine (spark plug dry when removed).
–
Check fuel tank level; check condition of fuel and impulse lines and their
connections. A failure of the fuel pump or carburetor has occurred. Contact
an authorized SKI-DOO dealer.
5. Spark plug/ignition (no spark).
–
Remove spark plug(s) then reconnect to spark cap. Check that engine cut-
out switch is at the ON position and the tether cord cap (DESS key) snapped
over the receptacle.
–
Start engine with spark plug(s) grounded to engine away from spark plug
hole. If no spark appears, replace spark plug. If trouble persists, contact
an authorized SKI-DOO dealer.
6. Engine compression.
–
As the engine is pulled over with the rewind starter, “cycles” of resistance
should be felt as piston goes past top dead center (each piston on multi-
cylinder engines).
–
If no pulsating resistance is felt, it suggests a major loss of compression.
Contact an authorized SKI-DOO dealer.
94
______________________
Содержание REV XP 2008 Series
