Ski-Doo REV XP 2008 Series, Руководство оператора

Страница: 125 / 155

– Remove rear wheel caps (if so
equipped).
– Loosen the rear idler wheel retain-
ing bolts.
– Turn adjustment bolts to adjust.
If correct tension is unattainable, con-
tact an authorized SKI-DOO dealer.
mmo2008-003-047_a
TYPICAL
1. Adjustment bolts
2. Loosen bolt
– Retighten retaining bolts.
– Check track alignment as described
below.
Alignment

WARNING
Before checking track alignment,
ensure that the track is free of all
particles which could be thrown
out while track is rotating. Keep
hands, tools, feet and clothing
clear of track.
Always lift the
snowmobile on a wide-base stand
with a rear deflector panel.
En-
sure no one is standing in close
proximity to the snowmobile, es-
pecially at the rear of the track.
Never rotate track at high speed.
Centrifugal force could cause de-
bris,
damaged or loose studs,
pieces of torn track, or an en-
tire severed track to be violently
thrown backwards out of the tun-
nel with tremendous force, possi-
bly resulting in the loss of a leg or
other serious injury.
Start the engine and accelerate slightly
so that track barely turns. This must
be done in a short period of time (15
to 20 seconds).
Check that the track is well centered;
equal distance on both sides between
edges of track guides and slider shoes.
A01F05A
1
2
3
1. Guides
2. Slider shoes
3. Equal distance
To Adjust Track Alignment:

WARNING
Remove the tether cord cap (DESS
key) before performing any main-
tenance or adjustment, unless oth-
erwise specified. Vehicle must be
parked in a safe place, away from
the trail.
– Remove the tether cord cap (DESS
key).
– Loosen rear idler wheel retaining
bolts.
– Tighten the adjustment bolt on side
where the slider shoe is the farthest
from the track insert guides.
A01F0BA
1 2
3
1
1. Guides
2. Slider shoes
3. Tighten on this side
Tighten retaining bolts.
_____________________
123