Ski-Doo EXPEDITION TUV, Руководство оператора

Страница: 39 / 135

All Models
To stop engine, turn off engine cut-
out switch or pull off tether cord cap
(DESS key).
If starter does not operate, check start-
ing system fuse condition. Refer to
STARTING SYSTEM AND ELECTRIC
POWER OUTLET FUSE
.
All Models except V800
NOTE: Engine may be manually start-
ed with rewind starter if necessary.
9) Tether Cut-Out Switch
General
When the tether cord cap (DESS key)
is removed, it shuts the engine off pre-
venting snowmobile to runaway if the
operator falls off the vehicle accident-
ly.

WARNING
Always remove ignition key or
tether cord cap (DESS key) when
vehicle is not in operation in order
to prevent accidental engine start-
ing, to avoid unauthorized use by
children or others or theft.
Operation
Attach tether cord eyelet to clothing,
then snap cap (DESS key) over post
before starting engine.
A06H1YA
2
1
TYPICAL
1. Snap over post
2. Attach to clothing eyelet
If emergency engine shut off is re-
quired, pull tether cord cap (DESS key)
from post completely.
®
A06H1XA
TYPICAL
DESS (Digitally Encoded
Security System) Key/
Cut-Out Switch
All Models except 550F
On these models, the tether cord cap
(DESS key) is digitally encoded to pro-
vide you and your snowmobile with
the equivalent security of a conven-
tional lock key and it shuts off the en-
gine preventing snowmobile to run-
away if the operator falls off the vehi-
cle accidently.
The DESS key provided with your
snowmobile contains an electronic
chip which features a unique perma-
nently memorized digital code. Your
authorized SKI-DOO dealer programs
this key in the ECM (Engine Control
Module) of your snowmobile to allow
engine operation above 3000 RPM if
and only if this unique code has been
read after engine starting.
If another DESS key is installed, the
engine will start but will not reach drive
pulley engagement speed to move ve-
hicle.
Make sure the DESS key is free of dirt
or snow.
_____________________
37