SKF Telemag TFG 1, Инструкция по установке, эксплуатации и обслуживанию

Страница: 20 / 41

20
L531
2,
1
675D
.0/
10.
10
Installation and initial start-up
Power supply
The telescopic pillar TFG runs solely on electricity. Observe the connection values in the
appendix of this manual (chapter
Equipment and operating data , page 33).
Installation and connections
Installing the telescopic pillar TFG on other elements (equipment carrier, etc.) involves
taking into account special requirements of different applications.
The telescopic pillar TFG attaches to two elements via the final and base plate and/or,
optionally, via adapter plates.
The following sections show how to set up and align the telescopic pillar, as well as the
interfaces and connections TFG.
Set-up and adjustment
In setting up and aligning the telescopic pillar, TFG the following points must be
observed. For the installation, you will require:
■
8 M6 fastening screws, property class 10.9
■
1 M10 fastening screw, property class 10.9
Make sure that
■
the telescopic pillar TFG is attached to elements of the application on both sides ,
■
all attachment points are securely screwed to the application,
■
the elements are fully aligned and seated at the top and at the bottom,
■
the acting force does not impact the guide tubes with inadmissibly high values, as
side-impacting forces that are too high can destroy the pillar,
■
the actuator is not obstructed in any way in the entire lifting area.
■
the cables are not pinched or caught or subject to tension stress.
■
If the TFG telescopic pillar is installed in horizontal position, a maximum torque
(Mb) of 500 Nm must not be exceeded at the bottom mounting plate.
■
If necessary, the outer tube must be supported by suitable measures (see Fig. 5-
2, page 22 ).
■
In the case of higher eccentric loads, please contact your local SKF representative
(
Manufacturer address , page 6).