Grease flow monitoring
Some.OEM’s.recommend.the.exact.amount.of..
grease.to.lubricate.critical.bearings .
Control/monitor grease application:
Refer to the display representations in
fig. 4.
Reset grease output reading to zero
1
Make sure that the gun is fully primed
(†”Prime the grease gun”, pg.13)
.
2
Press buttons “A” and “B” (
23
) simultane-
ously for 5 seconds to delete any previous
grease readings and reset display (
22
) to 0
(† fig. 4-A)
.
3
Grease gun is reset and ready for operation.
View grease output
1
Squeeze trigger to run and stop the gun at
desired output (0.2 oz. is shown in exam-
ple
4-B
)
.
2
Clear display (
22
) of current reading by
pushing button “
A”
(
23
) for 5 seconds.
3
Operate gun to next desired output, for ex-
ample, 0.5 oz.
4
To view total (accumulated) output (since last
reset), press button “B” (
23
) (0.7 oz. is shown
in example
4-C
)
.
Fig. 4
Fig.4-A
Fig.4-C
Fig.4-B
22
23
Expelling air pockets
(air purging)
1
Withdraw the follower rod from the grease
tube assembly cap and engage it with the
follower by rotating the follower handle.
2
Unscrew.the.plug.of.vent.valve.3.to.4.turns ..
Exert.force.on.the.follower.handle.until.
grease.flows.through.the.small.hole.in.the.
side.of.the.vent.valve .
3
Tighten.the.vent.valve .
4
If.step.2.fails,.unscrew.the.grease.tube..
assembly.3.turns.from.the.pump.assembly .
5
Exert.force.on.the.follower.handle.until..
lubricant.oozes.from.the.grease.tube..
assembly.and.pump.assembly.interface .
6
Retighten.grease.tube.into.the.pump..
assembly ..
7
Disengage.the.follower.rod.from.the.follow-
er.by.rotating.the.follower.handle ..
8
Push.the.follower.rod.into.the.grease.tube.
assembly .
14
A &
A HYDRAULIC
800-992-9898
