Refilling options
To fill gun from bulk container
1
Remove pump assembly from grease tube
assembly.
2
Pack lubricant into cavity of the pump
assembly.
3
Insert the open end of the grease tube
assembly into lubricant. Slowly pull the fol-
lower handle back while pushing the grease
tube assembly deeper into the lubricant to
prevent air pockets from being pulled into
the grease tube.
4
With the follower rod fully extended, pull it
sideways to latch the rod groove into the slot
in the grease tube assembly cap.
5
Loosely assemble the pump to the grease
tube assembly. Release the follower rod
from the grease tube assembly cap and
disengage the follower rod from the follower
by rotating the follower handle.
6
Push the follower rod into the grease tube
assembly.
7
Unscrew the grease tube assembly from
the pump until lubricant oozes from the
interface. Tighten grease tube assembly into
the pump assembly.
8
Reset.display.reading.after.purging.air
.
(†”Prime the grease gun” , pg. 13)
.
To fill gun with filler pump
1
Engage the follower rod with the follower
by rotating the follower handle.
2
Insert the gun bulk fill valve (
7
) into the filler
pump socket.
3
Operate the filler pump to fill the container.
When the follower rod groove is exposed, the
grease tube assembly is filled. The follower
rod will be extended approximately
8.in ..
(20 cm)
. Do not overfill!
4
Disengage the follower rod from the follower
by rotating the follower handle.
5
Push the follower rod into the grease tube
assembly.
6
Reset.display.reading.after.purging.air
.
(†”Prime the grease gun”, pg. 13)
.
Fig.5
7
15
A &
A HYDRAULIC
800-992-9898
