SKETCHNBUILD SNB-PX24, Руководство пользователя

Страница: 7 / 12

SNB-PX24 PLANER MANUAL
7
6/2016
12
Drive system of
delivery and
press roller
bearing 5
Take the end
cover apart
Cas#3
Every 6
months
13 Gear box gear 2
Take the end
cover apart
Cas#3
Every 6
months
14 Gera box Bearing 4
Take the end
cover apart
Cas#3
Every 6
months
15 Gear box
Chain
＆
chain wheel
2 Direct Engine oil
2 times per
shift
5. OPERATION
The motor is shared by the blade shaft, delivery and press roller. These mechanisms work
together once the Start button is pressed. Otherwise, the planer will stop when the Stop
button is pulled. The lever on work table works when the hand wheel is turned manually.
Release the fastener at the back of hand wheel when turning it to position the work table
then lock the fastener to keep the wheel position and make the work piece the same width.
Both rollers to the left and right sides of the breaker installed on top of planer use the same
setting as cutting the work piece a second time.
6. ADJUSTMENT
1. Up and down adjustment.
Before adjusting the position of work table, first release the fastener at the back of
hand wheel, and then turn the hand wheel left to adjust the work table. Fasten the
fastener to maintain position and to make the work piece the same width. When
adjusting, should check the index on work table position the scale on the gauge base.
This shows the thickness of the finished work piece in relation to the thickness of work
piece. Finally fasten the fastener after performing a cutting test and inspecting the
work piece. The thickness of most work pieces will be the same after performing the
above steps.
2. Sharpening and changing of planer blade should be done on worn blades which is
or after using for a period of time.
Use the steps below to change the blades: