15
Figure 2
Figure 4
8.3 Control system（Figure 5）：
Turn on the power control switch "A" start button, control power on.
Set the required temperature on the temperature control table B. When reaching the
set temperature, after ten minutes press the conveyor belt switch "E" start button,
conveyor belt running, press the corresponding switch motor operation.
In order to minimize the frequency converter, power outages, the system is not as
far as possible after the removal of artificial, to ensure the normal use of the
frequency converter.
When the wood into the machine touches the travel switch, push conveyor cylinder
edge forward. Board to enter the end of the trip to leave the trip, stop feeding.
Figure 5
8.4 Edge system：
This system adopts the edge banding machine mounted under the hot glue box, double
helix type glue feeding structure, ensure uniform glue glue feeding convenient. Edge
belt into the machine, roll edge away straight edge banding conveyor belt with sealing
device for workpiece linkage, with knurled wheel conveyor belt and the cylinder pressure
zone, knurled wheel is used for thin and soft edge banding. Banding belt pressing the
spring compression mode and pressure can be adjusted, into the edge belt, auto plate
spring pressure, the belt pressing roller and the roll round flower of complete tape
