12
Fine trim motor
0.75kW*2.200Hz.18000r/min
Buff motor
0.18kW*2.50Hz. 1400r/min
heat
1.5kW
Preheat
0.12kW
Power
7.0kW
Electric current
15A
Fine trim milling
D=Ф68. d=Ф16(+0.017+0.006)
End trim milling
D=Ф100. d=Ф22
Hot melt (reference resources)
160-200℃
Machine size
3940×900×1800 (mm)
Machine weight
About 1500kg
Chapter 6
: Transport
6.1 The machine can be carried through the body at the bottom of the forklift；
Warning：
In the beginning before moving, please confirm the lifting and handling equipment
should have sufficient bearing capacity.
In the handling and lifting process, should slow up the light, keep the balance.
Otherwise, it may affect the machining accuracy, and even damage the machine.
The lifting and handling process, prohibited under the machine and its adjacent
station, to prevent accidental injury.
If the machine must be stored, please keep the machine in the greenhouse and dry
environment, and the cover is sealed by a plastic bag.
Chapter 7
: Machine installation
7.1 Machine installation：
（1） the installation of the machine should be far away from the vibration source.
（2） the operation room should be cement ground, and check whether the ground is
smooth. Avoid shaking when the machine is adjusted.
（3） should put the machine in close proximity to the power supply, air outlet, the
waste pumping outlet position, the workplace should ensure adequate lighting, the
luminous flux of not less than 500Lx. Suggested that the vacuum cleaner flow rate
is greater than 800m/h, the flow rate is 25m/s. The machine vacuum interface with
100mm, the pressure is greater than 1100Pa, the flow rate is greater than 12m/s.
（4） the rubber boiler waste gas and waste plastic must be concentrated discharge,
and should meet the requirements of local environmental protection.
（5） around the machine should be set aside enough space for proper installation
and maintenance of equipment. The size of the space is determined by the size of
the sheet to be processed.
