SKC 224-44XRM, Руководство по эксплуатации

Страница: 11 / 19

10
Preventive Maintenance
To enhance battery life, SKC ships battery packs separate from the pump.
Once installed, completely charge the battery pack before operating the
pump.
Battery Pack Installation and Maintenance
Removal— Remove the two screws (Figure 1, #13) that secure the battery pack (Figure
1, #14) and loosen the case screws above and below the belt clip (two screws). Carefully
slide the battery pack out from under the belt clip (Figure 1, #16). Ensure that the battery
is kept level.
Replacement— Slide the front edge of the battery pack under the belt clip and position
the battery pack to engage the grooves in the case. Slide the battery pack toward the
pump until it is
fl ush with the pump case on all sides. Reinstall battery screws (Figure 1,
#13) and tighten the case screws (Figure 1, #13).
Charge Maintenance
For proper maintenance of battery packs, SKC offers chargers ( see Optional Accessories,
page 16 ) that condition the battery for optimum performance in 16 hours. Ensure pump is
not running during charging. Follow charger instructions.
To comply with intrinsic safety regulations, do not charge or operate the
pump from the charger in hazardous locations.
Using a non-approved charger voids any warranty.
Use of a repaired or rebuilt battery pack voids MSHA approval and any
warranty.
Use of any device other than the approved battery pack to power the pump
voids MSHA approval.
Ensure proper orientation of charging cable before plugging it into the
charging jack. Improper orientation/contact will short-circuit the battery and
voids any warranty.
Short-circuiting the battery pack will render it immediately inoperative.
Failure to follow warnings and cautions voids any warranty.
Fully charge packs before use. For more information on SKC pump batteries,
visit http://www.skcinc.com/instructions/1756.pdf.