skcinc.com
Form 37171 Rev 200630
Page 4
GETTING STARTED
Charging the Battery Pack
Set up the charging train (
Figure 2
) and completely charge the battery pack(s) before operating the pump.
1. Prepare charging cradle(s).
a.
Single cradle
: Insert connector on Single Cradle Power Supply Cat. No. 220-600 into power port
on side of Standard Charging Cradle Cat. No. 220-800 or Charging e-Cradle Cat. No. 220-900.
Insert wall cube into a 100 to 240-volt wall outlet.
b.
Up to five cradles
: Press together the connector on the side of the first cradle with the connector
on the side of the next cradle. Repeat the connection to chain up to five Standard Charging
Cradles. Insert the connector of Multi Cradle Power Supply Cat. No. 220-700 into the power port
on the side of the last cradle in the chain. Insert the wall cube into a 100 to 240-volt wall outlet.
2. Align the contacts on the bottom edge of the pump with the contacts inside the cradle and insert the
pump in the cradle. Repeat for each additional pump/cradle.
3. Charge the battery completely (approximately 3 hours). The left LED on the cradle will indicate
charging status. S
ee Reading Charge Status on Cradle LED and LED Activity Description
.
Figure 2. Charging Train, Single and Multiple Cradles
100-240 V
Wall outlet
Single cradle power supply
Power port
Charging contacts
Charging cradle
Charge status
Pump
Press connectors together
on cradles to chain up to
5 Standard Cradles or up to
4 Standard Cradles and
1 e-Cradle. Power with Multi
Cradle Power Supply
Cat. No. 220-700.
Multi Cradle power supply
