Skandia Elevator SE 140, Инструкция по техническому обслуживанию

Страница: 12 / 24

12
SKANDIA ELEVATOR
A
C
F
D
B
E
SE
! IMPORTANT!
When adjusting the position of the bucket belt on the belt wheels, only the following are
permitted:
- it is only permitted to lower the drive shaft in the elevator head for all apart from the new
generation SHE.
- it is only permitted to raise the drive shaft for the new generation SEH.
- it is only permitted to lower the tail end shaft in the elevator boot for SE.
NB! SEH 63/33 has tensioning bolts in the elevator boot only..
Example of elevator head:
Applies to SE, SEI and SEH apart from SEH 63/33 and the new generation SEH: Undo bolts (A)
in the left-hand bearing if the bucket belt is running to the right of the slatted pulley in the elevator
head. Lower the slatted pulley (B) by reducing the tension of the adjusting bolt/bolts (C) until the
bucket belt runs in the centre. Retighten the bolts in the bearing.
Applies to the new generation SEH:
If the bucket belt runs to the right of the drive wheel in the elevator head, loosen (not fully) the
bolts (A=4 pcs) and (B=6 pcs) on the right-hand side plate. Raise the drive wheel by tightening the
tensioning screws (C) using a socket wrench with extension (D) until the bucket belt runs centrally.
Retighten the bolts (A=4 pcs) and (B=6 pcs).
Example of elevator boot:
Applies to SE: Undo bolts (D) in the left-hand bearing if the bucket belt is running to the right of
the slatted pulley in the elevator boot. Raise the slatted pulley (E) by reducing the tension of the
adjusting bolt (F) until the bucket belt runs in the centre. Retighten the bolts in the bearing.
Applies to SEI, SEH and the new generation SEH: If the bucket belt is running to the right on
the slatted pulley in the elevator boot. Raise the slatted pulley (E) on the left-hand side plate by
reducing the tension of the tensioning bolt (F) until the bucket belt is running centred.