Skandia Elevator SE 140, Инструкция по техническому обслуживанию, Страница: 11 / 24

11
SKANDIA ELEVATOR
Tighten the bucket belt - Tensioning bolts in elevator boot
!
IMPORTANT!
If the adjustable slatted pulley in the elevator boot is to achieve
maximum capacity, it must be in as low a position as possible after the
bucket belt has been tensioned.
Tension the bucket belt with the tensioning bolts (C in illustration above) on
each side of the elevator boot. See recommended torque in the "Technical
specifications" section.
NB! It may be necessary to cut off a length of belt in order to tension it
sufficiently. If this is the case, follow the directions for assembling the bucket
belt in the assembly instructions.
Centre the bucket belt
!
IMPORTANT!
Ensure the bucket belt is centred on the drive- and slatted pulley.
Check how the bucket belt is running on the drive and slatted pulley. If it runs
askew then it must be centred.
Tighten the bucket belt - Belt tensioner in the belt seam and tensioning bolts
in the elevator boot
!
IMPORTANT!
If the adjustable slatted pulley in the elevator boot is to achieve maximum
capacity, it must be in as low a position as possible after the bucket belt has
been tensioned.
Tension the bucket belt with the belt tensioner on the bucket belt first as
instructed in the previous section.
Any later adjustment is done with the tensioning bolts (C) on each side of the
elevator boot.
C
C
New generation 50/18-63/30 SE-SEI-SEH