Skandia Elevator KTG, Руководство по сборке

Страница: 12 / 28

3.
Remove joining plates (X) as illustrated. Note! Other joining plates are used
during assembly.
Illustration A shows: Trench intake section and drive assembled directly to the
bend section.
Illustration B shows: Intermediate section assembled partly between trench
intake section and bend section, partly between bend section and drive.
bolts for assembling the conveyor are in the bag fastened to each machine
part.
2.
Remove the lid plates and the intermediate trays.
The conveyor can be assembled directly in place in the installation or
separately and then lifted in place. The design and space requirements of
the installation and the length of the conveyor will determine which method is
most suitable.
!
IMPORTANT!
• The conveyor length must not exceed 14 meters (45.9 ft) if being
lifted after assembly. Its weight must be distributed over several
lifting points, with one supporting the support frame of the drive. The
maximum distance between lifting points is 12 meters (39.4 ft).
• The maximum span between supports for a standard conveyor is 6
meters (19.7 ft). This distance is 12 meters (39.4 ft) if cable supports
are used.
• Relieve the weight of the drive with braces supported on the ground
and/or a nearby stable construction. If the machine has a geared
motor, brace its support frame. Never use the motor/geared motor to
brace against.
1.
Lay out the machine parts in the order in which they are to be assembled.
12
SKANDIA ELEVATOR – KTG
Before assembly