sitrex TR/11, Сборка, использование и обслуживание

Страница: 38 / 40

37
GREASE TYPE: NLGI 1
A: Normally, lubricating the machine every 50 hours is sufficient, but to facilitate operation,
it is a good practice to lubricate it when it has not been used a long period of time.
B: When exposed to weather these parts are subject to rusting, therefore each time that
the machine is left unused for long periods (especially during the winter) brush the
hydraulic cylinder piston rods with grease. When possible, keep the cylinders retracted so
that a minimum part of the piston rod is exposed outside the cylinder barrel.
C: The wheels must pivot freely, but without becoming uncontrollable. Check disk wear
each season.
D: Check the tire pressure each time the machine is used, especially when it has not been
used a long period of time. if necessary inflate to the proper pressure according to the
information printed on the tires.
MAINTENANCE POINTS
POS. Qty. DESCRIPTION OPERATION
EVERY X
HOURS
1 4 WHEEL SUPPORT LUBRICATE 50(A)
2 1 FRONT DRAWBAR SUPP. LUBRICATE 50(A)
3 1 WHEEL AXLE, SIDE REAR LUBRICATE 50(A)
4 1 WHEEL AXLE, SIDE REAR LUBRICATE 50(A)
5 1 FRONT AXLE DRAWBAR ATTACH. LUBRICATE 50(A)
6 1 SECTION JOINT LUBRICATE 25
7 11-13 RAKE WHEEL ARM JOINT LUBRICATE 25
8 11-13 RAKE WHEEL HUB LUBRICATE 25
9 4 PIVOTING WHEEL BRAKE CHECK EFFICIENCY C
10 5 TIRES CHECK PRESSURE D
11 2 CYLINDERS CLEAN-LUBRICATE B