sitrex TR/11, Сборка, использование и обслуживание

Страница: 25 / 40

24
Step 15
Step 15
Before attaching the wheel assembly 2, brush pin B and pin 6 with grease.
Insert nylon bushings 4 in the seats in section 1. Place the shim 3 over the pin of the wheel
assembly 2.
Insert the preassembled wheel assembly 2 into the seat in section 1.
Attach the flange 5 to the pin on wheel assembly 2 using the spring pin 6.
Attach the grease nipple 12 to the seat in section 1.
Check to make sure that the wheel assembly 2 turns freely in the seat in section 1.
Attach the plate with screw 7 underneath flange 5.
Attach the counterplate 8 over the flange 5, inserting its pins into the holes in plate with screw 7
and in section 1.
Attach the spring 9, washer 10 and nut 11 to the screw on plate 7.
IMPORTANT:
The more spring 4 is compressed by tightening nut 11, the more the wheel rotation is braked,
therefore check that it is properly adjusted before using the machine.
In this step use the following parts:
Position 3: 1 shim ø50-76x5 (1.97”x3”)
Position 4: 2 nylon bushings ø50-60x50 (1.97”-2.36”x1.97”)
Position 6: 1 spring pin ø10x80 (0.4”x3.15”)
Position 9: 1 spring ø5-30x45 (0.20”-1.42”x0.1”)
Position 10: 1 washer ø12-36x2.5 (0.47”-1.42”x0.1”)
Position 11: 1 nut (0.47”)
Position 12: 1 grease nipple M8