sitrex SB150, Сборка, использование и обслуживание

Страница: 13 / 36

ASSEMBLY, USE AND MAINTENANCE
11
STARTING UP and USE
FRAME
Connect the Mower to the three-point attachment of the
tractor inserting the gear rack in the pin of the third
point, rest the chain "D" against it and connect the ends
to the frame with the relative clamps. Regulate the
stabilizing tie-rods so that the machine is well cantered.
Block the support in the working position and extract
the stop pin of the frame.
CONNECTING THE CARDAN SHAFT
It is your responsibility to read and comply with this documentation. If information given in this
manual should conflict with that given in the Cardan shaft manual, you should follow the
instructions given by the Cardan shaft manufacturer.
Fit the Cardan shaft and check that the shaft is connected correctly both at the tractor end and at
the machine end. For more details, see the descriptions on the following pages. If a safety system
is provided, this should be fitted to the machine end, not to the tractor end.
During both transport and use, avoid
conditions where the Cardan transmission
shaft is extended to the maximum. In all
working conditions, the telescopic tubes must
overlap by at least 1/3 of their length.
Conversely, when the Cardan shaft is
contracted to the maximum, there should still
be a gap of approximately 50 mm (2").
WARNING !!!