Sit 190 Series, Инструкции по использованию и установке

Страница: 12 / 28

12
English
CauTION
EquIPmENT DamaGE HazaRD.
ImPROPER PlaCEmENT OF WRENCH WIll DamaGE GaS ORIFICE.
uSE CauTION WHEN PlaCING THE WRENCH TO avOID BENDING INjECTOR.
Top convertible Pilot Hood
1. The pilot hood is held in place by spring pressure. Remove the hood by simply pulling it directly
up from the pilot bracket (fig. 10).
2. Insert a 5/32" (4 mm) Allen wrench into the hexagonal key-way of the injector (fig. 11), and turn
counter clockwise to remove it from the injector journal.
3. Verify that the new injector is proper for the application. The injector size is stamped on the side
of the injector near the top. LPG injectors have a groove machined around their circumference
near the top, while NG injectors do not have a groove (fig. 13).
Refer to the Appliance Manufacturer’s instruction sheet for the proper injector size.
4. Insert the Allen wrench into the end of the injector. Then, install the injector into injector journal,
and rotate the injector clockwise until a recomended torque of 9 lbf in (1.0 Nm) is achieved.
5. Replace the pilot hood by aligning the tab on the base of the hood with the slot in the side of the
pilot journal, and push the hood down, directly onto the pilot bracket (fig. 12). The hood must sit
squarely on the bracket for proper operation. Check to insure that the hood is properly seated
onto the pilot bracket.
6. Restore the gas supply to the appliance, and ignite the pilot burner.
Verify proper ignition and operation.
LPG
NG
Injectors
Fig. 10 Fig. 11 Fig. 12 Fig. 13