Sissel Portal Pro Therapy Chair, Инструкция по эксплуатации

Страница: 8 / 24

Setting up your chair
Make sure the cable is fully extended before
sitting on the chair.
1. Lean your chair forward and lift the
back of the seat until fully open.
2. Remove the plastic covering from the wheels and feet.
Chair height, seat angle & height adjustment
These adjustments can only be made
when no one is on the chair.
Cable system changes the height of the chair.
To change cable setting:
1. Lift seat to relax tension on the cable and remove the
“Z” clip from the seat hole.
2. Insert the “Z” clip into the correct hole and pull back on
seat tube until the cable is taut. The “Z” clip should lay
flat against the seat tube.
Raising and lowering the seat height
also changes the seat angle.
A good basic seat position is when the seat is angled downward toward the front feet, with the back
of the seat higher than the front. Lumbar strain can be reduced by raising the seat height one to two
holes.
To change the seat height
Push in button on seat tube while raising or lowering the
seat. Release button when proper height is achieved.
Be sure the push button is fully engaged and the
seat tube is not resting on “Z” clip before sitting on
the chair.
!
!
!
30950 • GA Portal Pro_GA Hydrotemp 02.07.15 10:07 Seite 8