background image

UPA-61W

Safety Related Symbols

This symbol, wherever used, alerts you to the 

presence of uninsulated and dangerous voltages within 

the product enclosure. These are voltages that may be 

sufficient to constitute the risk of electric shock or 

death. 
This symbol, wherever used, alerts you to important 

operating and maintenance instructions. 

Please read. 
Protective Ground Terminal
AC mains (Alternating Current)
AC mains (Alternating Current) 
Denotes the product is turned on.
Denotes the product is turned off.

WARNING 

Describes precautions that should be observed to 

prevent the possibility of death or injury to the user. 

CAUTION 

Describes precautions that should be observed to 

prevent damage to the product.Disposing of this 

product should not be placed in municipal waste but 

rather in a separate collection.

WARNING Power Supply 

Ensure that them a inssource voltage (AC outlet) 

matches the voltage rating of the product. Failure 

to do so could result in damage to the product and 

possibly the user. Unplug the product before electrical 

storms occur and when unused for long periods of 

time to reduce the risk of electric shock or fire. 

External Connection 

Always use proper ready-made insulated mains cabling 

(power cord). Failure to do so could result in shock/

death or fire. If in doubt, seek advice from a registered 

electrician. 

Do Not Remove Any Covers 

Within the product are areas where high voltages may 

present. To reduce the risk of electric shock do not 

remove any covers unless the AC mains power cord 

is removed. Covers should be removed by qualified 

service personnel only. 

No user serviceable parts inside. 

Fuse 

To prevent fire and damage to the product, use only 

the recommended fuse type as indicated in this 

manual. Do not short-circuit the fuse holder. Before 

replacing the fuse, make sure that the product is OFF 

and disconnected from the AC outlet. 

Protective Ground 

Before turning the unit ON, make sure that it is 

connected to Ground. This is to prevent the risk of 

electric shock.Never cut internal or external Ground 

wires. Like wise, never remove Ground wiring from the 

Protective Ground Terminal.

Operating Conditions 

Always install in accordance with the manufacturer

'sinstructions.To avoid the risk of electric shock and 

damage, do notsubject this product to any liquid/rain 

or moisture.Do not use this product when in close 

proximity to water.Do not install this product near any 

direct heat source.Do not block areas of ventilation. 

Failure to do so could result in fire.Keep product away 

from naked flames.

IMPORTANT SAFETY INSTRUCTIONS 

Read these instructionsFollow all instructions Keep 

these instructions. Do not discard.Heed all warnings.

Only use attachments / accessories specified by 

themanufacturer.

Power Cord and Plug 

Do not tamper with the power cord or plug. These 

redesigned for your safety.Do not remove Ground 

connections! If the plug does not fit your AC out let 

seek advicefrom a qualified electrician.Protect the 

power cord and plug from any physical stress to avoid 

risk of electric shock.Do not place heavy objects on 

the power cord. This could cause electric shock or 

fire.

Cleaning 

When required, either blow off dust from the productor 

use a dry cloth.Do not use any solvents such as 

Benzol or Alcohol.For safety, keep product clean and 

free from dust.

Servicing 

Refer all servicing to qualified service personnel 

only. Do not perform any servicing other than those 

instructions contained within the User's Manual. 

PORTABLECarts and stands - The component should 

be used

CART WARNING

only with a cart or stand that is recommended by the 

manufacturer. A component and cart combination 

should be moved with care. Quick stops, excessive 

force, and uneven surfaces may cause the component 

and cart combination to overturn. 

Содержание UPA-612W

















Отзывы: