SIRS-E Pilotino WiFi PCB, Инструкция по эксплуатации, Страница: 7 / 20

6 Installation .
Standoffs
Four 2.5M x 5mm standoffs should be used to properly mount the unit onto a smooth and level surface. It is recommended
that the included factory 2.5M stand offs be used. To fasten the P
WiFi™ PCB onto a surface, first the four
ILOTINO
screw
screws in a crisscross pattern. To tighten the screws, torqued them down to ¼ turn past hand tight, in in a crisscross aga
pattern. Always tighten the screw opposite to the last screw that was torqued down. Do not over tighten the screws as doing
so will result in damage to the device.
Clearance
Due to the exposed contact points on the P WiFi™ PCB, the risk of shorting the unit should be considered. A minimum
ILOTINO
of 10mm of clearance space is recommended. Never install the P WiFi™ PCB within an enclosed space in which the
ILOTINO
P WiFi™ PCB does not have sufficient space away from other components.
ILOTINO
Connections
The P WiFi™ PCB comes equipped with wire to board quick connectors, and a socket connector
ILOTINO
to connect to the
P ™ PCB
ILOTINO ILOTINO ILOTINO
. Properly connect the P WiFi™ PCB to the P ™ PCB with the boards facing the same direction.
All wire connections should fit securely into the connectors. Be sure to insert each wire into the connectors deep enough so
that no bare wire is exposed. A good rule of thumb is to strip the wires so that only about 3mm of insulation is removed.
To have the best network connection, place the P WiFi™ PCB in a location where the antenna has a clear line of
ILOTINO
sight from the device connected to.
7
3307 West Street Rosenberg, TX 77471 USA - (281) 324-0908
Copyright © 2006-2021 SIRS Electronics Inc. All Rights Reserved
P WiFi™ PCB Instruction Manual
ILOTINO
Updated 12/2021. Rev 2.7