ASSEMBLY INSTRUCTIONS (CONT.)
6. Place the FLOOR HEATER COVER on the FLOOR PANEL. Once heater wires are connected and BENCH SUPPORT
is installed, use six 1-1/2” (40mm) SCREWS to attach HEATER COVER to FLOOR.
5. Place the LEFT SIDE WALL PANEL on the FLOOR in the same manner and buckle it to the BACK WALL PANEL.
6
4. Place the BACK WALL PANEL on the FLOOR as shown and make sure it fits snugly against the RIGHT SIDE
WALL PANEL with wall fititng into groove and trim overlapping wall, then engage buckles.
Place ring over knob
and snap buckle closed
The LEFT SIDE WALL has a glass
panel that will need to be
installed next to it and attached
to FLOOR and ROOF in Step 10B
and Step 11.
TIP: You may need to move
FLOOR HEATER COVER in order
to make it easier to insert screws
in bottom of wall panel in
Step 10, so DON’T attach the
HEATER COVER to FLOOR until
after Step 10 is completed.