11 / 14
10.REPEAT
This is used for adjusting frequency of echo repeat.
Since too much echo repeat may cause a howl. Please
adjust frequency properly.
11.und 12.AUX1;AUX2 OUT
This socket sends out the signal from AUX bus.
13.EFF/RETURN
This is used for adjusting volume of echo sound when
connecting sound to return jack.
14.;15.und 16.DELAY
This is used for adjusting the time interval of echo
repeat. The middle position (5) may be most effective.
17.Meters
The three-color peak reading meters normally show the
level of the Mix R und L outputs, giving you a constant
warning of excessive peaks in the signal which might
cause overloading.
When any SOLO switch is pressed, the meters switch
to show the selected Solo signal on both meters, in
mono. The SOLO LED also lights.
18. Master Fader
The master faders set the final of the mix outputs.
These should normally be set to the “0” mark if the input
gain settings have been correctly set.
