10 / 14
4. Master Section
1.und 2. MIX OUTPUTS & INSERTS
The Mix L and R outputs are balanced XLR outputs. The
MIX Inserts are unbalanced sockets.
3.PLAYBACK IN
The two phone sockets are unbalanced L and R line-level
inputs, used for connecting a recording device.
4.REC OUT
These are two outputs to connect a recording device.
5.und 6.PHANTOM POWER
Man professional condenser mics need phantom power,
which is a method of sending a powering voltage down
the same wires as the mic signal. Press the switch (5.) to
enable the +48V power to all of the MIC inputs. The LED
(6.) lights when the power is active.
Note: Take care when using unbalanced mics which may
be damaged by the phantom power voltage. Balanced
dynamic mics can normally be used with phantom power
switched on (contact your microphone manufacturer for
guidance). Mics should always be plugged in, and all
output faders set to the minimum before switching the
phantom power on to avoid damage to external
equipment.
7. PHONES
The Phones output is a socket which ideally for
headphones of 200
Ω
or greater. 8
Ω
headphones are not recommended.
8.AUX TAPE
You can adjust the volume of AUX IN signal by this when connecting AUX IN.
9. PHONES LEVEL
This control sets the output level to the headphone. The monitor output levels are not affected.
