Siqura IFD820 Series, Руководство по установке, Страница: 17 / 28

Installation
Page 15
4. Press the sides of the snap-on camera module, as indicated in the figure, and detach it from
the dome camera’s housing/plate.
5. Mark the positions of the four screw holes on the base of the dome camera at the chosen
installation location.
6. In the marked locations, drill each hole slightly smaller than the supplied screw anchors, and
insert the anchors into these holes.
7. Fasten the dome camera’s housing/plate with the four supplied self-tapping screws.
8. Thread the cables (power/Ethernet/audio/alarm) through the hole in the base plate.
Note:
The power cable is omitted if using PoE.