Siqura FD820M1IR, Руководство по установке

Страница: 15 / 39

To connect directly to a PC
● Connect one end of a crossover Cat 5 cable to the RJ-45 connector of the IP camera and
the other end of the cable to the PC.
Refer to the following figure to determine whether you have established an Ethernet
connection.
Ethernet socket LEDs green/yellow
Green on/off : 100/10 Mbit
Yellow on/blink : link OK, active
Yellow off/flash : link down, TX attempt
4.4 Connect audio
If microphones and speakers are configured to the network, the FD820 can be used to provide
a two-way audio channel.
To connect audio
● Connect the audio input and output connectors to the terminal block on the back of the
camera.
For the location of this block and the audio connectors, see Connectors.
To configure audio settings
1 Log on to the webpages of the camera.
For instructions on how to do this, see the User Manual.
2 On the Streaming menu, click Audio.
3 Select one of the following options:
- Full-duplex (talk and listen simultaneously)
- Half-duplex (talk or listen, not at the same time)
- Simplex (talk only)
- Simplex (listen only)
- Disable
4.5 Connect alarm I/O
The camera equips one alarm input and one relay output for alarm application.
To connect an alarm device
● Connect the alarm relay connectors to the terminal block on the back of the camera.
Connectors and cabling
15