14
Installation
3.
Press the sides of the snap-on module, as indicated in
the figure, and detach it from the dome housing.
4.
Attach the dome housing to the appropriate mounting
location on the wall, and mark the positions of the four
screw holes with a pen or a pencil.
5.
In the marked locations, drill a hole slightly smaller
than the supplied screw anchors.
6.
Insert the anchors into these holes.
7.
Fasten the dome housing with the four supplied
screws.
8.
Thread the power and video cables through either the
side conduit entry or back conduit entry. Users may
use a coin to screw the conduit entry block off.
