DRAFT
© 2003 - 2005 Sipura Technology, Inc
Proprietary (See Copyright Notice on Page 2)
35
The Administrator has the privilege to modify all the web profile parameters and can also modify the
passwords of both Administrator and User. A User only has the privilege to access part of the web profile
parameters; the parameter group that User can access is specified by the Administrator, which can only
be done through provisioning.
To access the Administrator level privilege, use URL: http://IP_Address_Of_SPA/admin/. If the password
has been set for Administrator, the browser will prompt for authentication. The username for Administrator
is “admin” and cannot be changed.
To access the User level privilege, use URL: http://IP_Address_Of_SPA/. If the password has been set
for User, the browser will prompt for User authentication. The username for User is “user” and cannot be
changed.
When browsing Administrator pages, one can switch to User privileges by click the link “User Login”.
(
Note
: if User password was set, the browser will prompt for User authentication when you click “User
Login” link). On the other side, from the User pages the user can switch to Administrator privilege by
clicking the link “Admin Login.” Authentication is needed if Administrator password has been set.
Warning:
Switching between the User and Administrator will discard the uncommitted changes that have
already been made on the web pages.
Web Interface Basic and Advanced Views
The web configuration interface provides a Basic and an Advanced view from which the various
configuration parameters can be accessed. The SPA Provisioning tab is only visible from the Advanced
Administrator view of the web interface.
Warning: Switching between the basic and advanced view will discard the uncommitted
changes that have already been made on the web pages.
10 SPA-841 Configuration Parameters
This section tabulates all the SPA-841 parameters. The parameters can be configured in 2 ways: a)
phone configuration web page, and b) remote provisioning. In addition, a small subset of “user options”
can be set via the phone’s GUI under various setup menus.
On the configuration web page, the parameters are organized into several groups with each group hidden
under a “tab” on the top of the web page. To see the group of parameters, the user click on the
corresponding “tab” on the web page. The following groups are defined at present:
•
Info – Status Information (read only). This is the default “tab” when the web page is first loaded.
•
System – System level parameters, including network and debug parameters
•
SIP – Parameters to adjust the SIP stack behavior
•
Provisioning – Parameters that control remote provisioning
•
Regional – Parameters that depends on country or region, such as call progress tones and *
codes
•
Phone – Parameters that apply to all the extensions configured for the phone
•
Ext 1 – Parameters that apply to Extension 1
•
Ext 2 – Parameters that apply to Extension 2
•
Ext 3 – Parameters that apply to Extension 3
