SIP CW2300, Руководство по сборке, Страница: 11 / 16

EN
11
The plug must NOT be used if the cover is omitted
or lost until a replacement is obtained.
- Make certain that only the correct fuse cover is
used and fitted.
- For plugs with detachable fuse cover the
replacement must be the same as the colour
insert in the base of the plug, or as directed by the
embossed wording on the base of the plug.
- If the detachable fuse cover is lost a replacement
may be purchased from a Service Centre.
PUT INTO SERVICE / STARTING
UP
See fig.
A
- Connect the high pressure hose to the trigger gun.
- Push the high pressure hose into the trigger gun.
Note: Make sure the connection nipple is aligned
correctly.
- Check the secure connection by pulling on the
high pressure hose.
See fig.
B
- Insert the high pressure hose tightly into the quick
coupling on the appliance
See fig.
C
- Screw the coupling element to the water
connection on the appliance.
- Attach the water supply hose to the coupling on
the water connection.
NOTE: The supply hose is not included.
- Connect the water supply hose to the water
supply.
- Completely open the water tap.
- Insert the mains plug into the socket.
- Turn on the appliance “I/ON”.
See fig.
D
- Unlock the lever on the trigger gun.
- Pull on the lever of the trigger gun; the device will
switch on.
- Switch the appliance on for a (max. of 1 minute)
and wait until the water exits at the hand spray
gun without bubbles.
- Release the lever on the trigger gun.
NOTE: Release the lever of the trigger gun; the
device will switch off again.
- High pressure remains in the system.
See fig.
E
- Lock the lever on the trigger gun.
Operation
See fig.
F
- Push the spray lance into the trigger gun and fasten
it by turning it through 90°.
- Unlock the lever on the trigger gun.
See fig.
G
- Pull on the lever of the trigger gun; the device will
switch on.
• 14WARNING: Appliance with fluid under pres-
sure. Keep a firm hold on the gun and be prepared
to take the kickback pressure.
See fig.
H
> HIGH PRESSURE LANCE
See fig.
K
> DETERGENT SUCTION
See fig.
L
> HIGH PRESSURE HOSE
Use the hydrocleaner only if the hose is completely
uncoiled and extended.
See fig.
M
> SWITCHING OFF
T.S. Total Stop
( if fitted)
NOTE: Total Stop, which stops the machine
during the bypass phase. To start the water
cleaner, it is therefore necessary to set the switch
on position (I)“ON”; after that press the pistol
trigger: the Total Stop will start the machine
and will stop it automatically when the trigger is
released. It is advisable to put on the safety of the
pistol trigger whenever the machine is stopped,
in order to avoid unintentional starting.
- Any automatic start of the machine without
pressing the gun trigger is attributable to air
bubbles in the water or other similar phenomena
which do not imply the existence of any defects in
the machine.
- Do not leave the appliance unattended during
the standby for more than 5 minutes. Contrarily,
for the safety of the appliance it is necessary to
re-turn the switch into the (0) OFF position.