12
ASSEMBLY INSTRUCTIONS
FITTING THE SPARK ARRESTOR / EYE SHIELD
Note:
The spark arrestor should be set close to the grinding wheel, without
touching; turn the wheel by hand to ensure there is no contact.
As well as holding the eye shield in place; The spark arrestor is designed to reduce the
amount of sparks that are directed back towards the operator.
Locate the spark arrestor (Fig. 1).
The spark arrestor fits onto the main guard (Fig. 2).
Fit the spark arrestor and secure in place with the screw, washers and nut (Fig. 3)
Follow these instructions to fit the other spark arrestor to the opposite side (07546 &
07557 only).
Fig. 1
Fig. 3
Fig. 2
Fit Here
17
MAINTENANCE….cont
REPLACING THE GRINDING WHEEL (WET)
Loosen and remove the screws that hold the water carrier in place; there are 3
screws, 2 either side of the gearbox (see below, left) and one on the bottom of
the gearbox (below, right).
Hold the grinding wheel, or the opposite one, with one hand and turn the retain-
ing nut clockwise for the left hand wheel, and anti clockwise for the right hand
wheel.
Remove the nut, outer flange and the grinding wheel.
Ensure that the shaft and flanges are clean and free from burrs etc.
Refit the flanges and wheel etc. as shown below.
Follow the instructions above, but in reverse to secure the new wheel and cover
etc.
Remove the water carrier.
Loosen and remove the wheel retaining nut by turning it anti clockwise.
Remove the nut, outer flange and the grinding wheel.
Screws
Inner Flange Outer Flange
Shaft Wheel Nut
Blotter Blotter
