26
WIRING DIAGRAM WELDMATE T136 MIG
11
ELECTRICAL CONNECTION
WARNING!
It is the responsibility of the owner and the operator to read, understand
and comply with the following:
You must check all electrical products, before use, to ensure that they are safe.
You must inspect power cables, plugs, sockets and any other connectors for wear or
damage.
You must ensure that the risk of electric shock is minimised by the installation of appro-
priate safety devices; A residual current circuit Breaker (RCCB) should be incorporated
in the main distribution board. We also recommend that a residual current device
(RCD) is used. It is particularly important to use an RCD with portable products that are
plugged into a supply which is not protected by an RCCB. If in any doubt consult a
qualified electrician.
Connecting to the power supply:
The T126 and T136 are supplied with a 13A plug pre-fitted.
The T166 is supplied without a plug fitted, it must not be connected a 13A supply,
consult the technical specification table (page 13) for the required rating, if in doubt
contact a qualified electrician. Before using the welder, inspect the all the leads and
plugs to ensure that non are damaged. If any damage is visible have the welder in-
spected / repaired by a suitably qualified person.
The wires for the plug are coloured in the following way:
Yellow / green
Earth
Blue
Neutral
Brown
Live
As the colours of the wires may not correspond with the markings in your plug, pro-
ceed as follows:
The wire which is coloured brown, must be connected to the terminal, which is
marked L or coloured red.
The wire which is coloured blue, must be connected to the terminal marked with N or
coloured black.
The wire which is coloured yellow / green should be connected to the terminal which
is coloured the same or marked with this symbol
Always secure the wires in the plug terminal carefully and tightly. Secure the cable in
the cord grip carefully.
