SIP 01938, Инструкция по эксплуатации, Страница: 8 / 12

8
TECHNICAL SPECIFICATIONS
Part Number 01938
Input Voltage 230v ~ 50hz
Power 550 watts
Speed 500 rpm - 2000 rpm (variable)
Distance Between Centres 900 mm
Maximum Turning Ø 310 mm
Spindle Thread Size 3/4” x 16tpi
Drive Spur Size 1 Morse Taper
Tailstock Rotating Centre Size 2 Morse Taper
CONTENTS AND ACCESSORIES
17
OPERATING INSTRUCTIONS….cont
• When using the tool rest extension arm, loosen lock levers (5) and (6) to make
any necessary adjustments.
•
Be certain to tighten all tool rest locking levers before turning on the lathe.
• The articulated tool rest may also be repositioned onto the extension bed for
use on outboard turnings.
IMPORTANT: Make sure that the tool rest is adjusted to be as close to the work-piece
as possible, without touching. Rotate the work-piece by hand to check the clear-
ance
before turning the lathe on.
On / Off NVR Switch:
To start the lathe; lift the yellow cover and press
the green button (I).
To stop the lathe; press the red (0) button, or al-
ternatively close the yellow cover.
Your variable speed SIP wood lathe is fitted with
a safety NVR (No Volt Release) switch. This
means that if power is cut to the lathe (such as
in a power failure); the motor will not start to run
once the power is returned without the operator
following the above instructions to restart the
lathe.
Speed Control:
The lathe motor
must be running before you
can use the speed control lever.
The speed control lever can be rotated to any
one of ten fixed speeds; To set the speed:
•
Pull back on the speed control lever (1)
and rotate the lever to the desired speed.
Use the index plate (2) as a reference to
select the desired speed.
•
Rotating the lever clockwise will increase
the speed while a counter clockwise rota-
tion decreases the speed.
Always return the speed control lever to the lowest speed position before turning the
lathe off. Not complying may prevent the motor from starting and / or cause damage
to the lathe.