SIP 01938, Инструкция по эксплуатации

Страница: 7 / 12

18
MAINTENANCE
WARNING - FOR YOUR OWN SAFETY; ALWAYS TURN THE LATHE OFF AND DISCONNECT IT
FROM THE MAINS SUPPLY BEFORE PERFORMING ANY MAINTENANCE OR LUBRICATION
WORK ON THE LATHE.
• Vacuum and / or blow out any dust accumulation inside the motor housing on
a regular basis.
•
Apply a coat of paste wax, or similar to the lathe bed to help keep it clean and
to facilitate the easy movement of the articulated tool rest and tailstock.
• Proper Oiling and maintenance must take place to ensure the quality and life of
the machine. To Maintain this, the use of a pin point oiler would be helpful. Take
the headstock cover off, and oil the point in the diagram. This should be done
periodically.
Periodic lubrication of the spring levers and other threaded parts will make them easier
to operate and prevent any possible corrosion.
7
SPECIFIC SAFETY INSTRUCTIONS….cont
• When an extension cable is required, you must ensure that it has the right am-
pere rating and a large enough cross section for the mini wood lathe. It should
also be checked to make sure that no damage is present and it is in safe elec-
trical condition.
•
Ensure that you have removed foreign objects such as nails and screws from
the work-piece before commencing the operation.
•
Rags, cloths, cord, string and anything that could get “dragged” into the lathe
should be removed from the work area prior to use.
• Damaged or contaminated work-pieces may cause unwanted hazards.
•
Metal parts penetrated into the work-piece can be very dangerous, and should
be removed before operation starts.
•
Use safety equipment including safety goggles or shield, ear protection, dust
mask and protective clothing.
• Check to make sure that all fixing screws etc. are tight before operating the
lathe.
WARNING! Before connecting the tool to the mains supply be sure that the
voltage supply is the same as that specified on the nameplate of the tool.
A power source with a voltage greater or lower than that specified for the
tool can result in serious injury to the user, as well as damage to the tool. If
in doubt, do not plug the tool into the mains supply. Always turn the ma-
chine off and remove the plug from the mains socket before making any
adjustments or maintenance.
When using this wood lathe, always ensure the operator as well as
those in the area wear ear protection; particularly during extended use.
When using this wood lathe always ensure the operator as well as those
in the area wear eye protection.
Some wood and wood composites / additives have the potential to be
highly toxic; always wear a face mask when operating this wood lathe.