SINUS Tango Plus, Руководство пользователя

Страница: 9 / 48

1.5 First use
Figure 1.5: Numeric Display
The Numeric Display shows the value of
the levels selected at the bottom.
Figure 1.6: Info Measurement
The Info Display shows information on tabs
for:
•
Measurement: Name, Date,
Duration, Time and File size
•
Microphone: Calibration date, time
and status as well as sensitivity
and microphone connection mode
(section 3.1 and 3.2)
•
Hardware: Firmware version, Har-
dware revision, serial numbers of
Preamplifier and Microphone cap-
sule (see also table 2.2 : Device >
Info)
NOTICE!
A warning appears, if the original preamplifier is not detected. A Measu-
rement can still be performed, but an according remark is connected with
it.
1.5 First use
Pay attention to the following notes before using the device for the first time:
•
Read carefully the manual and follow the instructions before using the device.
•
Insert the batteries as described in section 1.3.1.
•
Install the required software on a PC (driver and
Tango-Utilities
).
•
Connect the device with the PC using the supplied USB cable.
•
Switch on the device by pressing the On/Off-Button (minimum 3 seconds).
SINUS Messtechnik GmbH 9 of 47 Manual Tango_Plus